Winter Is Coming. Has Your Swimming Pool Equipment Been Maintained?

Over time, the season of headaches for major swimming pool merchants has come again, and that is winter. Both the passenger flow and the maintenance of the swimming pool equipment are a headache. So, do you know about the maintenance of winter swimming pool equipment?

The first is to choose whether to maintain water. The general engineering construction of the swimming pool is below the pavement. After the swimming season has passed, if there is no water in the pool for a period of time, because of the surrounding earth pressure, the merchant pool is very prone to cracks. However, if there is water in the pool, it will definitely cause algae plants to freeze in the cold area, which is a hazard to the pool. Different maintenance methods should be adopted based on different selections.

Dry test maintenance mode without water.

After the swimming pool is stopped, drain the water, clean it and keep it clean. In addition, keep the water release valve always open or fully automatic drainage to maintain the operation. Later, when the average temperature dropped to 0 ° C, the following two methods can be used to carry out cold protection measures for the swimming pool and improve the maintenance during the winter icing period.

1. Cover the pond with straw mat or wheat straw and the suspension on the inner wall of the pond, and then cover it with a plastic film.

2. Cover the pool and side walls with two layers of plastic film.

The water-cooled maintenance method of residual water.

This method is suitable for areas where there is no icing period in winter or a short icing period. Its advantages are less cost and convenient management methods. But pay attention to the following tasks

1. Solve the impact of chlorine in the pool water.

2. Keep the water body balanced at a slightly negative number to prevent the pool water from causing fouling.

3. Add algicides to avoid the growth and development of algae plants.

4. Application of pesticide fungicides to avoid the survival of germs.

5. If freezing occurs, add air pump to the pool water to digest and absorb the stress of the swimming pool when the volume of the pool water is surging.

Swimming pool equipment

The maintenance of the swimming pool in the room.

The swimming exhibition hall in the room must have detailed heating, natural ventilation (supply air in winter and air conditioning in summer) and temperature-control and cold-prevention heating equipment (constant temperature pool equipment), so that the temperature of the swimming pool must be considered. In order to maintain the temperature, in addition to the moderate heating according to the temperature release situation every day, attention should be paid to maintaining the average temperature in the room. If the average temperature in the room is lower than the temperature of the water, the heat of the pool water will be released quickly, and there will be water leakage on the ceiling and the wall surface in the room, which will easily erode the building; Makes swimmers feel uncomfortable when inhaling. In general, the temperature of the swimming pool in the room is preferably higher than the indoor temperature of 2-3 ° C, so that the temperature is not easy to release, and the pool water can maintain a moderate temperature.